Comments in MATLAB
Comments are generic English sentences, mostly written in a program to explain what it does or what a piece of code is supposed to do. More specifically, information that programmer should be concerned with and it has nothing to do with the logic of the code. They are completely ignored by the compiler and are thus never reflected on to the input.
In MATLAB, comments are of two types:
- Single-line Comments
- Block Comments
- Spanning MUltiple Lines
Single-Line Comments
Single-line comments are comments that require only one line. They are usually drafted to explain what a single line of code does or what it is supposed to produce so that it can help someone to refer to the source code. Use % operator for adding single-line comments. This can be written in a separate line or appended to code on the same line.
Syntax :
% single line comment
Example :
MATLAB
disp( "Below is the comment using %" ); % this is a comment |
Output :
Below is the comment using %
Block Comments
To make a block comment just put a ‘%{‘ in the starting of the block and ‘%}’ at the end of the block.
Syntax:
%{ multiline comment %}
Example :
MATLAB
disp( "Below is the block comment using %" ); %{ this is a comment using % %} |
Output :
Below is the block comment using %
Comments Spanning Multiple Lines
Commenting part of a statement spanning multiple lines uses ellipsis (…).
Example :
MATLAB
%{ a = [1 2 3] b = 5 %} x = [ 'Matlab is a ' ... 'programming language' ... ... 'invented by Cleve Moler' ... ', it is user friendly' ] |
Output :
Matlab is a programming language, it is user friendly
To comment out the lines of code in a script, press Ctrl + R, to uncomment them press Ctrl + T.